Tribological behavior of composites fabricated by reactive SPS sintering in Ti‐Si‐C system - Université Polytechnique des Hauts-de-France Accéder directement au contenu
Article Dans Une Revue International Journal of Applied Ceramic Technology Année : 2019

Tribological behavior of composites fabricated by reactive SPS sintering in Ti‐Si‐C system

Résumé

In this study, wear and friction behavior of two based-composites from the Ti-Si-C system, (40 wt% TiC; 28 wt% Ti5Si3; 17 wt% Ti3SiC2) and (18 wt% TiC; 26 wt% Ti5Si3; 41 wt% Ti3SiC2) reinforced by 15 wt% of large size SiC (100-150 µm) particles were investigated. The four-phase composites exhibited approximatively the same friction coefficient (µ ~ 0.9) under high loads (10 N and 7 N). The composite with high Ti3SiC2 showed higher wear rate values by one order of magnitude. However, under 1 N, the composite with high TiC content showed a higher running-in period and a lower steady state µ value (0.37 after 1000 m sliding distance). Scanning electron microscopy, Energy Dispersive X-Ray and Raman spectroscopy analysis of the worn surfaces of the two composites revealed that oxidation was the dominant wear mechanism. The oxidation process and the removal kinetics of the oxides during sliding controlled the tribological behavior of the composites. The influence of processing variables on microstructures development and wear mechanisms of the composites is discussed.
Fichier non déposé

Dates et versions

hal-03479330 , version 1 (14-12-2021)

Identifiants

Citer

Youcef Hadji, Abdessabour Benamor, Nabil Chiker, Adel Haddad, Nacer Tala-Ighil, et al.. Tribological behavior of composites fabricated by reactive SPS sintering in Ti‐Si‐C system. International Journal of Applied Ceramic Technology, 2019, 17 (2), pp.695-706. ⟨10.1111/ijac.13443⟩. ⟨hal-03479330⟩
9 Consultations
0 Téléchargements

Altmetric

Partager

Gmail Facebook X LinkedIn More